49
4. Turn the unit over to drop out the two 3 volt lithium batteries. Discard,
regardless of age or amount of use. Closely examine the metal contacts
inside the battery compartment, checking for any signs of stress (bending
or breakage) or corrosion which may indicate the entrance of moisture
into the unit. If found, return your PRODIGY to your Authorized Oceanic
Dealer or Oceanic Parts & Service, and DO NOT attempt to use until it
has received service. You may otherwise proceed to the next step.
5. Install two new 3 volt lithium batteries (Duracell® DL 2032, Radio
Shack® 23-162, Maxell® CR 2032, or Panasonic® CR 2032) into the
battery compartment directly on top of each other with the positive (+)
side of both facing up. NOTE: Use caution to avoid touching either the
battery contacts or the flat surfaces of the batteries, as skin oil will impair
correct contact.
6. Lubricate and install a new o-ring onto the battery hatch, checking to
ensure that it is evenly seated inside the groove at the base of the threads.
DO NOT roll the o-ring over the threads of the battery hatch. Instead,
stretch it slightly to work it down over one thread at a time. NOTE: This
o-ring must be a genuine Oceanic Part, purchased from your Authorized
Oceanic Dealer. Use of a non-Oceanic o-ring will void the warranty.
7. Carefully thread the battery hatch into the case back turning clockwise by
hand until snug. Using a nickel or quarter, tighten until the outer surface
of the hatch is flush with the outer surface of the case back.
R5
To Next Page
Loading...
