Oceanic Prodigy - Battery Replacement and Service

47
PRODIGY BATTERY REPLACEMENT INSTRUCTIONS
Removing the Module From Its Boot
1. If the module is in a wrist boot, it will be necessary to peel the lips of the
boot downward off the gauge while applying pressure from underneath,
working it out slowly. If in a console, bend the rubber console boot back to
expose the edge of the module. If the console boot is flexible enough to
permit, you may bend it back far enough to scoop the module out with
your index finger. Otherwise, it may be necessary to insert a blunt screw-
driver until the tip rests just underneath the module. DO NOT pry the
module from the console! Slowly increase the pressure under the module
by releasing the tension on the rubber boot. The module will slide up the
screwdriver and exit the console.
2. Verify that your PRODIGY contains user replaceable batteries by examin-
ing the case back to find the battery hatch (Fig. 33a).
Fig. 33 – PRODIGY
battery hatch
H
A
N
D
T
I
G
H
T
E
N
0
P
E
N
USE
COIN ONLY
a.
b.