Ochsner Air Eagle 717 - Page 25

BA_OCHSNER AIR EAGLE_414_717_V06_EN.docx Page 25 of 76
1
Grip rail
2
Guide pin
3
dotted line (perforation in the metal plate)
4
Guide groove
5
Positioning aid
Figure 34: Assembling the appliance sections 1
1
dotted line (perforation in the metal plate)
Figure 35: Positioning aid
- Place the top appliance section onto the
bottom appliance section at the dotted line.
Figure 36: Assembling the appliance sections 2
- Slide the top appliance section towards the
rear until it is flush with the bottom section.
When the appliance sections are assembled
correctly, the end position is given by the
guide groove and the guide pin.
- Fasten the tabs at the front of the appliance.
- Fit the thermal insulation element and the
4 hydraulic hoses.
- Fit the plug-in connectors of the 4 hydraulic
connections. Ensure that the spring clips
engage.
- Plug in the sensor on the buffer tank.
- Route the sensor cable in the guiding groove
in the thermal insulation element.