OHAUS EXPLORER PRO - Balance Preparation for Density Measurement

Explorer Pro EN-31
USE
Balance Preparation for Density Measurement
The Explorer Pro Balance is equipped with a weigh below
hook which can be attached to the bottom of the balance.
When making density measurements, it is necessary to sup-
port the balance on both sides allowing enough clearance
to for a beaker to fit under the balance, a platform or labo-
ratory jacks can be used. Remove the protective adhesive
cap from the bottom of the balance as shown in the figure
below. Screw the weigh below hook into the bottom of the
balance.
BOTTOM OF BALANCE
WEIGH BELOW
HOOK INSTALLATION
LOCATION
PLATE
PROTECTIVE
COVER
WEIGH BELOW HOOK
BALANCE SUPPORT