OHAUS EXPLORER PRO - 5. Technical Data; 5.1 RS232 Commands

EN-48 Explorer Pro
Command
Character Description
C Begin span calibration
xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
PM Application mode.
xFL Set Averaging Filter Level 1= Low, 2= Medium, 3= High
L Begin linearity calibration
P Print displayed weight (stable or unstable)
T Same as pressing Tare key.
PV Version: print name, software revision and LFT ON (if LFT is set ON)
xAL Set Auto-Zero level to x. x = 0 for OFF, x = 1 for 0.5d, x=2 for 1.0d, x=3 for 2.0d, x=4 for
5.0d.
Esc R Resets Setup and Print menus to factory defaults
On Turns balance on
Off Turns balance off
x% Set % reference weight (x) in current unit
x# Set PC reference weight (x) in current unit
P# Print PC reference weight
P% Print percent reference weight
xM Set current Application mode to x. x = 1 for Weighing, x = 2 for Parts Counting, x = 3 for
Animal Weighing, x = 4 for Percent Weighing, x = 5 for Check Weighing, x = 6 for G/N/T,
x = 7 for Filling, x = 8 for Differential, x = 9 for Formulation, x = 10 for Statistical, x = 11
for SQC, 12 = for Density
xAW Set Animal Weigh Level to x. x = 1 for LOW, x = 2 for MEDIUM, x = 3 for HIGH.
xAM Set animal mode. Where x is 1=Manual, 2=Semi and 3=Auto
SAW Start Animal cycle.
xT Download Tare value in current unit. Sending 0T clears tare.
PID Print current user ID string
xID Program user ID string. 1-8 characters
AC Abort calibration
xUC Set user defined weight
UC Initiate user calibration
IC Initiate internal calibration
PTIME Print current time
mm/dd/yyDATE Set date
hh:mm:ssTIME Set time
PDATE Print current date
5. TECHNICAL DATA
5.1 RS232 Commands
Field: Weight Unit Stab CR LF
Length: Max 9 5 1 1 1