After selecting the import file, the Import button is
available.
Press Location to change the import location.
Press Import selection to select methods to
import.
Press Cancel to return to previous screen.
7.2 Method parameters (drying parameters)
7.2.1 Drying program
The drying program (profile) contains four settings, Standard, Fast, Ramp and Steps. This section
describes each of the drying profiles. Review the profile descriptions. Depending upon the sample
material to be analyzed, select the appropriate profile and proceed as follows:
Press the Drying program button.
Ramp Profile
For this temperature program, the
temperature and time elapsed between the
start of drying and the attainment of the final
temperature is set.
To Next Page
Loading...
