Troubleshooting 112
TROUBLESHOOTING
The network addresses used in this manual are shown for example only.
Network addresses used in your installation must be generated from your
own network.
Self-diagnostic test
Printer does not print.
Ensure the printer emulation is set to PS (if available) or Automatic.
NG is printed in the Self-diagnostic test.
Confirm that the NIC is installed correctly in models that require an
optional NIC card and turn the printer off and on again.
Ensure the network cable is correctly connected and connect to a different
network segment, rerun the test and see if this cures the fault.
EEPROM Check registers NG.
Confirm that the NIC is installed correctly and turn the printer off and on
again.
Initialize the NIC.
To Next Page
Loading...
