Oki B4300 User Manual

Configuration 38
Using TELNET
The OkiLAN can be configured using TELNET. TELNET requires the
OkiLAN to have a valid IP address configured. If the NIC already has an
IP address configured, skip steps one to three below.
> Note: Please ensure that a valid IP address for you network
environment is used. Use of an incorrect IP address can cause
serious problems on your network.
The following explanation uses Sun Solaris 2.4 as an example. The
method of configuring commands may differ between workstations. Refer
to the workstation’s manual.
1. Login as [root].
If you do not have Superuser rights, the network manager should run the
configuration.
2. Set a temporary IP Address on the NIC using the ARP command.
Example: for IP address 192.168.20.127 and network card address
00:80:92:01:00:D2
# arp –s 192.168.20.127 00:80:92:01:00:D2 temp
The Ethernet address (MAC address) is displayed during the self-
diagnostic test. A temporary address does not need to be set if an IP
address has already been set.
3. Use the PING command to confirm the connection with the
network card.
Example: for IP address 192.168.20.127
# ping 192.168.20.127

Oki B4300 Specifications

General

Brand	Oki
Model	B4300
Category	Print Server
Language	English