Configuration 26
To find corresponding items in WEB and TELNET, see the equivalent in
the Configurable Items and Default Values table that starts on page 46.
Netware Tab
This is where you can configure NetWare related items.
Location Comments
Use NetWare Protocol Set NetWare protocol as enabled/disabled.
Print Server Name Set Print Server name.
Frame Type Set primary NetWare frame type.
Operation Mode Set NetWare mode.
Check box besides Bindery
Setup
Check if you want to use the Bindery mode and Bindery
Setup button becomes available. If it is unchecked, the button
is greyed out.
Bindery Setup Configure items related to Bindery mode.
In this dialogue box, the following items can be configured.
Available File Server and
Selected File Server.
Select file servers to connect.
Up to eight file servers can be
selected. Select a server from
Available file server list and
click >>. The server is copied
to Selected file server box.
Password. Set password for Print Server.
Job Polling Time. Set print job polling interval
in seconds.
To Next Page
Loading...
