Configuration 29
SNMP Tab
This allows you to configure SNMP related items.
Location Comments
Authentic
Community
This community name is used to check whether incoming SNMP requests
have the correct community name or not. The community name is
displayed as ****** for security reasons.
TRAP
Community
This community name is assigned to outgoing system traps such as cold
start, authentication failure, etc.
TRAP Address Set a destination IP address of a Trap packet. If 0.0.0.0 is set, the Trap is
disabled.
SysContact Set SysContact (printer manager) name.
SysName Set SysName (printer model name).
SysLocation Set SysLocation (the location where the printer is installed).
Default TTL Set TTL (Time To Live) value.
Enable Authentic
Trap
Set Authentic Trap to enabled/disabled.
To Next Page
Loading...
