Configuration 30
Printer Trap Setup
. . .
By selecting the button, the following dialogue box is displayed:
In the dialogue box, the following items can be configured:
Printer Trap
Community Name
This community name is assigned to outgoing
printer status traps such as off-line, paper out, etc.
TCP#1—5 Set the IP address to which a Trap packet will be
sent. You can set up to five IP addresses.
Detail . . . By selecting the button, the following dialogue
box is displayed:
In the dialogue box, the following items can be
configured:
Trap Enable Set sending a Trap
packet, enabled or
disabled, for each
destination.
On-Line Set sending a Trap,
enabled or disabled,
when the printer turns to
On-Line.
On-Line Set sending a Trap,
enabled or disabled,
when the printer turns to
Off-Line.
Paper Out Set sending a Trap,
enabled or disabled,
when paper is out.
Paper Jam Set sending a Trap,
enabled or disabled,
when paper is out.
Location Comments
To Next Page
Loading...
