Configuration 67
To install the OKI LPR utility
The OKI LPR utility requires that the TCP/IP protocol should be installed
in your Windows system. To install the TCP/IP protocol into your
Windows system consult your Windows manual.
Windows XP/2000/NT4.0 requires administrator privileges.
1. Set up the printer driver by designating the output destination to
[Local Printer (LPT1:)]. For information on setting up your printer
driver, see the printer user manual.
1. Insert the CD-ROM provided with your printer into the CD-ROM
drive. If the Menu Installer doesn’t start automatically, click
Start→Run→Browse. Browse to your CD-ROM and click
Install→Οpen→OK.
2. Select [Network Software].
3. Select [Installation/Config]
4. Select [Oki LPR].
5. Follow the on-screen instructions.
6. Select [Install Oki LPR].
7. Follow the on-screen instructions.
8. Click [Next] when the [Welcome] screen is displayed.
9. Verify [Destination Folder] and [Spool Folder] and click [Next].
10. Check [Register in Startup] if you want automatic startup as
Windows boots up. Check [Launch as minimized] if you want to
startup in the Icon state and click [Next].
11. Verify the program folder name and click [Next]. The installation
starts.
To Next Page
Loading...
