Configuration 12
Using Quick Setup
Quick Setup utility allows you to configure the print server easily and
simply without installing any software packages.
You can configure the following:
> Enable/disable TCP/IP, NetWare, EtherTalk, NetBEUI protocols.
> Set IP address, Subnet Mask and Gateway for TCP/IP manually or
by using DHCP.
> Set NetWare mode and create Queue/Print Server/Printer objects.
> Zone name and Port name for EtherTalk.
Configuration requires a PC with Windows 95/98/Me, Windows 2000
Advanced Server/Professional or Windows NT Server 4.0/Work-station
4.0, Windows XP running TCP/IP or IPX/SPX (NetWare).
This utility can only be used on a PC that can be connected to the network
with TCP/IP or IPX/ SPX.
This utility must be used on a PC that is located in the same segment as
the printer. To create a NetWare queue, NetWare Client 32 or
IntranetWare Client should be installed in your system.
To Next Page
Loading...
