Oki B4300 - Page 33

Configuration 31
Printer Trap Setup
. . .
Detail . . . Cover Open Set sending a Trap,
enabled or disabled,
when the printer cover
opens.
Printer Error Set sending a Trap,
enabled or disabled,
when any errors occur.
IPX Set node address and network address to which a
Trap packet will be sent.
Detail . . . By selecting the button, the following dialogue
box is displayed:
In the dialogue box, the following items can be
configured:
Trap Enable Set sending a Trap
packet, enabled or
disabled, for each
destination.
On-line Set sending a Trap,
enabled or disabled,
when the printer turns to
On-Line.
Off-line Set sending a Trap,
enabled or disabled,
when the printer turns to
Off-Line.
Paper Out Set sending a Trap,
enabled or disabled,
when paper is out.
Paper Jam
Set sending a Trap,
enabled or disabled, when
a paper jam occurs.
Printer Trap Setup
. . .
Detail . . . Cover Open Set sending a Trap,
enabled or disabled,
when the printer cover
opens.
Printer Error Set sending a Trap,
enabled or disabled,
when any errors occur.
Location Comments