Configuration 44
7. When configuration is complete, select [Exit Setup] to save your
change. To exit without saving your modification, select [Quit].
8. Turn the printer off and on again.
The network card continues to use pre-transmission settings until the
printer is turned off and back on again.
9: Setup SMTP(E-Mail) 12: Signature line 1
13: Signature line 2
14: Signature line 3
15: Signature line 4
—
SMTP-20
99: Back to prior menu
—
—
10: Setup POP (E-Mail) 1: POP3 protocol
—
POP-1
2: POP3 server
—
POP-2
3: POP port number
—
POP-3
4: POP3 server UserID
—
POP-4
5: POP3 server Password
—
POP-5
6: Use APOP
—
POP-6
7: Retrieve every (min.)
—
POP-7
99: Back to prior menu
—
—
97: Reset to factory set
——
ETC-1
98: Quit setup
—— —
99: Exit setup
—— —
Level1 Level2 Level3 Ref No.
To Next Page
Loading...
