Oki B930dn User Manual

B930n User’s Guide> 94
PRINTING
To specify the output format of printing, enter the following
command:
-C, [Parameter], [Parameter]
Enter a "," (comma) after -C followed by the parameters which
specify the output format. To specify multiple parameters, separate
them with ",".
For example, to output a file named "file1" 2-sided on A4 to printer
"P001", enter the following command:
%lpr -P P001 -C, DUP, A4 file
Important:
> If the command specified by the -C option exceeds 64
characters, the operation may not function correctly.
PRINTING FROM A MACINTOSH COMPUTER
PRINTING FROM A MACINTOSH COMPUTER
This section explains the installation procedure for printing from a
Macintosh computer.
SYSTEM CONFIGURATION
As the printer supports EtherTalk and LPD protocol, you can print
from Macintosh. NOTE > Printing using the LPD protocol is available
only with the Mac OS X.
TARGET COMPUTERS
The printer supports a Macintosh or Power Macintosh with the
following OS:
• Mac OS 10.2 and up
SET UP PROCEDURE
The setting procedure is as follows:
1. Use the printer Operator Panel or EWS to set the following
port to [Enable].

Oki B930dn Specifications

Performance

print speed	50 pages per minute
time to first page	7 seconds
print resolution	1200 x 1200 dpi
CPU	600 MHz
duty cycle	300, 000 pages per month

Memory

standard RAM memory	256 MB
maximum RAM memory	768 MB
bitmapped fonts	47 PCL

Weight and Dimensions

dimensions	20.0" x 25.0" x 21.0" (50.8 cm x 63.5 cm x 53.3 cm)
weight	90.0 lb. (32.1 kg)
paper size	5.8" x 8.3" min. to 11" x 17" max.