Oki B930dn User Manual

B930n User’s Guide> 85
3. Registering a logical PostScript printer PS01 set using the
EWS.
#lpadmin -p P003 -s printer1\!PS01
NOTE
> Enter the host name and printer name of the remote host
after -s by linking with !. The printer name corresponds to
the print language/mode.
> The output style may be specified at the same time. The
parameters for specifying a style are the same as those
available for the -C option. As the example of (2) shows,
insert "_" between the printer name and output
parameters. You can enter up to 14 characters.
> If PS%n or PLT%nH is specified for the printer name as in
the example of (3), however, the printer does not operate
normally with an output style different from the preset
one.
> Set a printer name corresponding to the print language/
mode and output style.
Refer to:
• Manuals, such as online manuals, that came with various
workstations.
PRINT (LP)
The "lp" command is used for printing.
C OMMAND F ORMAT
lp [-d Printer name] [-n No. of copies] File name
C OMMAND O PTIONS
The following command options are available:
-d Printer name
Specify the printer name registered by the "lpadmin" command as
the -d option. If this option is omitted, the default printer lp will be
specified.

Oki B930dn Specifications

Performance

print speed	50 pages per minute
time to first page	7 seconds
print resolution	1200 x 1200 dpi
CPU	600 MHz
duty cycle	300, 000 pages per month

Memory

standard RAM memory	256 MB
maximum RAM memory	768 MB
bitmapped fonts	47 PCL

Weight and Dimensions

dimensions	20.0" x 25.0" x 21.0" (50.8 cm x 63.5 cm x 53.3 cm)
weight	90.0 lb. (32.1 kg)
paper size	5.8" x 8.3" min. to 11" x 17" max.