Oki B930dn User Manual

B930n User’s Guide> 95
> The EWS allows more detailed settings.
2. Setting up the Macintosh
Install the printer driver (Adobe PS) for Macintosh. Install the
screen font if necessary. Connect the printre to the network
and select Add Printer via the printer setup utility or Printers
and Faxes and the Plus button. Select Other using the Print
Menu and browse to select the B930n ppd. Add options
installed on the printer.
SNMP SUPPORT
The printer can be managed via a standard SNMP management
station. The printer supports SNMP-v1, SNMP-v2c, MIB-II, Host
Resources MIB, Printer MIB and OKI Data Private MIB.
PRECAUTIONS AND LIMITATIONS
ON USING TCP/IP
This section explains the precautions and limitations of using this
printer with TCP/IP.
Setting Up the Printer
• Be very careful in setting up IP addresses which are
controlled as an entire system. Consult your network
administrator before performing any setup on IP addresses.
• Depending on the network environments, some require
subnet mask and gateway to be set up. Consult your network
administrator and set up the necessary items.
Setting Up the Computer
• Be very careful in setting up IP addresses which are
controlled as an entire system. Consult your network
administrator before performing any setup on IP addresses.
• Before performing any network setup (such as the IP
address) to a host running under NIS (Network Information
Service), consult the NIS administrator.
When setting a UNIX workstation, note the following also:

Oki B930dn Specifications

Performance

print speed	50 pages per minute
time to first page	7 seconds
print resolution	1200 x 1200 dpi
CPU	600 MHz
duty cycle	300, 000 pages per month

Memory

standard RAM memory	256 MB
maximum RAM memory	768 MB
bitmapped fonts	47 PCL

Weight and Dimensions

dimensions	20.0" x 25.0" x 21.0" (50.8 cm x 63.5 cm x 53.3 cm)
weight	90.0 lb. (32.1 kg)
paper size	5.8" x 8.3" min. to 11" x 17" max.