B930n User’s Guide> 96
• The setup procedures and commands may vary according to
different versions of OS. Refer to the manuals that came with
the workstation for the details.
• To setup the printer, the user must be a superuser. Contact
your network administrator to perform the setup if you do
not have the authority of a superuser.
• The print language/mode is determined by the printer model
and configuration. Before setting a UNIX workstation, check
the available languages/modes.
• To specify multiple entries for the logical printer, make sure
each printer entry is assigned its own unique spool directory.
If a single spool directory is used for multiple printer entries,
the printer select option may not function correctly.
PRINTING FROM WINDOWS
Take note of the following when printing from Windows:
• In the spool mode, if the print data is bigger than the
remaining capacity of the hard disk or the memory at the
point of receiving, the data will not be received by the printer.
NOTE
> Some client computers may re-send immediately when
the print data has exceeded the receiving capacity. When
this occurs, the client appears as if it has crashed. To
rectify this situation, the client computer must be stopped
from sending print data.
> In the non-spool mode, printing will commence once data
starts to be received by the printer. Therefore, if the
printer has accepted a print request from a computer, it
will not receive another print request from another
computer.
> For PCL and DUMP, the specification for the number of
copies is invalid.
PRINTING FROM UNIX
Take note of the following when printing from UNIX:
To Next Page
Loading...
Need help?
Performance
Memory
Weight and Dimensions
