Oki C5650 - Page 117

43827101TH Rev.2 117 /
Oki Data CONFIDENTIAL
Table 5-2 Maintenance Utility Adjustment Items (1/3)
Operation on
Operator Panel
(Section No. corresponds to
the Maintenance manual)
Item
Section No. of the
Maintenance Utility
Operation
Adjustment
1
2
3
4
5
6
7
8
9
10
11
Invalid operation
Invalid operation
Subsect. 5.3.2.10
Invalid operation
Invalid operation
Invalid operation
Invalid operation
Invalid operation
Invalid operation
Invalid operation
Invalid operation
PU PCB
Replacement
PU Serial Number
Setting
Factory/Shipping
Mode
Replacement of
CU PCB
Serial Number
information setup
Set information of
PCB items
USB software
update
NIC software
update
NIC Web Page
update
Mac address setup
Consumable part
counter
maintenance
function
Subsect. 2.4.1.1.1
Subsect. 2.4.2.1.1,
if copying of
corrected data of
LED head is
involved.
Section 2.4.1.1.2.1
Section 2.4.1.1.2.2
Section 2.4.1.1.6.4
Subsect. 2.4.1.1.3
Subsect.2.4.1.1.4.3
Subsect. 2.4.1.1.7
Section 2.4.2.2.1
Section 2.4.2.2.2
Section 2.4.2.2.3
Section 2.4.2.2.4
Section 2.4.2.2.4
Copying of the EEPROM of PU PCB.
Adjustment purpose: The above data is copied
to another PU PCB in the event that the
current PU PCB needs to be replaced due to
maintenance replacement.
Reprogramming printer serial number
recorded on PU
Adjustment Purpose: Set for a board replaced
for maintenance when it is impossible to copy
EEPROM of the PU PCB (I/F error etc.)
Switching between Factory mode and
Shipping mode.
Adjustment purpose: If the EEPROM of the
PU PCB cannot be copied (I/F error, etc.),
setting is made on a maintenance
replacement PCB. Since the maintenance
replacement PCB usually comes set to the
Factory mode, it needs to be set to the
Shipping mode by this function.
Rewrite of the EEPROM set values of the CU
PCB. Adjustment purpose: The EEPROM data
is rewritten to another CU PCB in the event
that the current CU PCB needs to be replaced
due to maintenance replacement.
Selection of the printer serial number recorded
on the CU, and rewrite of the output mode and
device serial numbers.
Verification of the serial No. information and
Factory/Shipping mode.
Update of USB software
Update of NIC software
Update of NIC Web Page
Setup of Mac address
Copying of consumable part counters
Drum counter (Y, M, C, K)
Fuser counter
Belt counter
Toner counter (Y, M, C, K)
Adjustment purpose: When half-used
consumable parts are diverted to another
printer, the value of each consumable part is
copied.