43827101TH Rev.2 160 /
Oki Data CONFIDENTIAL
5.5 About the manual setup of Print density adjustment
The printer is shipped out of the factory with its automatic density correction mode set to "Auto".
However, if that mode is changed to "Manual" by the user, the density setting may be displaced
with the use along the time. Execute this manual setup when the density appears below par.
Note!
Make the setup when the printer remains at a standstill. Do not conduct it during warming-
up.
(1) Press the MENU+ or MENU- key several times, and when [COLOR MENU] is
displayed, press the ENTER key.
(2) Press the MENU+ or MENU- key to cause [DENSITY ADJUSTMENT/ RESET] to be
displayed.
(3) Press the ENTER key.
Automatic Print density adjustment will start.
To Next Page
Loading...
