Oki C5650 - Feeder Unit; Front Sensor PCB; MPT Hopping Roller; Frame Assy Separator; Cover Front

43827101TH Rev.2 88 /
Oki Data CONFIDENTIAL
4.2.16 Feeder Unit / Front sensor PCB/ MPT Hopping Roller / Frame Assy Separator
/ Cover Front
(1) Open the top cover.
(2) Remove the plate shield, and unplug the connector. (See Subsection 4.2.6.)
(3) Free the claws of Stay L 1 and Stay R 2, and remove feeder unit 3 by sliding it to the right.
(4) Detach the motor cover. (See Subsection 4.2.12.)
(5) Disassemble cover sensor 4 by freeing the claw.
(6) Unplug the connector, and disassemble Front sensor PCB 5.
(7) Remove MPT Assy. (See Subsection 4.2.15.)
(8) Detach lever 6 by turning it until its claw is freed.
(9) Remove two screws (black) 7, and detach stay L 1.
(10) Remove four screws (black) 8, free two claws B on the front side, and disassemble feed
Assy 9.
(11) Detach two lock shafts 0 and two springs A, and disassemble guide Assy B by freeing the
four claws.
(12) Remove hopping roller shaft C.
(13) Free the two fulcrums, and remove frame assembly separator D and spring E.
Figure 4-2-16 Feeder Unit / Front sensor PCB/ MPT Hopping Roller / Frame Assy Separator
/ Cover Front
0
0
B
4
A
A
1
7
7
6
5
E
D
2
C
3
9
8
8
Claws B
Claw