Oki C5650 - Guide Eject Assy; Color Register Assy; Junction PCB

43827101TH Rev.2 84 /
Oki Data CONFIDENTIAL
4.2.13 Guide Eject Assy / Color Register Assy / Junction PCB
(1) Detach the left side cover, right side cover, rear cover, and top cover assembly. (See
Subsections 4.2.1, 4.2.2, 4.2.4, and 4.2.8.)
(2) Remove the print engine controller PCB, control PCB, and low-voltage power supply. (See
Subsections 4.2.6, 4.2.7, and 4.2.12 (3).)
(3) Unplug the connector of the belt thermistor, remove two spring torsions 1, and disassemble
cover driver 2 by freeing the four claws with the flat-tipped screwdriver.
(4) Remove screws (silver) 3, and unplug the six connectors to disassemble Junction PCB 4.
(5) Remove two screws (silver) 5, and disassemble color register Assy 6.
(6) Remove two screws (silver) 7, and free cable 8 of the fuser I/F connector from the clamp.
Then, release the claw of guide cable 9 by sliding it, and remove guide eject Assy 0.
Figure 4-2-13-1 Guide Eject Assy / Color Register Assy / Junction PCB
FUSER
LCR
RCR
DENS
EXIT
PUIF
1
5
6
2
0
7
8
4
3
7
4
Claws
Claws