43827101TH Rev.2 137 /
Oki Data CONFIDENTIAL
Display Function
REG ADJ EXECUTE Execution of Color registration adjustment
REG ADJ RESULT Viewing of the Color registration adjustment result
BLT REFLECT TEST Execution of the judgment of good or bad Color registration
adjustment belt reflectivity
BLT REFLECT RSLT Viewing of the result of judgment of good or bad
Color registration
adjustmentbelt reflectivity
5.3.2.7 Print density adjustment test
This self-diagnosis is practiced to conduct testing on the Print density adjustment function of the
printer and to view the execution result. This test is executed also to judge whether the Print density
adjustment mechanism is normal or abnormal.
1. Activate the self-diagnostic (Level 1) mode, and press and hold down the [MENU+] key or
[MENU-] key, until the following message appears:
2. Pressing the [ENTER] key causes the following message to appear. Press and hold down the
[MENU+] key or [MENU-] key, until the intended item is displayed.
3. Pressing the [ENTER] key executes the test of the item currently displayed on the panel.
<< DENS ADJ EXECUTE is executed>>
1 A density correction test is conducted. ([READY] light blinking)
2 When the test ends, the test result (OK or error name) appears in the upper line of the
display section, and **** RESULT, in the lower line.
Pressing the [MENU+] key increments the test result sequentially in the display.
Pressing the [MENU-] key decrements the test result sequentially in the display.
Pressing the [BACK] key restores the status of Item 2.
3 Pressing the [CANCEL] key while the test is under way aborts the test ([READY] light comes
on) and restores the status of Item 2.
<<BLT REFLECT RSLT is executed>>
The same as the key operation of Item2. in the execution of BLT REFLECT TEST.
4. Repeat Items 2 and 3, as needed.
5. Press the [BACK] key to terminate the test. (Status of Item 1 restored)
Color registration adjustment test items
DENS ADJ TEST
DENS ADJ TEST
DENS ADJ EXECUTE
OK
DENS ADJ RESULT
To Next Page
Loading...
