Oki C5650 - Page 179

Oki Data CONFIDENTIAL
43827101TH Rev.2 179 /
Table 7-1-2 Service Call Error (4/7)
Service call
142:Error
Service call
150:Error
~
153:Error
Service call
154:Error
Service call
155:Error
Service call
160:Error
~
163:Error
Service call
167:Error
Service call
168:Error
Service call
169:Error
Is ID unit set properly?
Does error reoccur?
Is ID unit setting proper?
Does error reoccur?
Is error recovered by replacing
PRT board?
Is belt unit setting proper?
Does error reoccur?
Is fuser unit set properly?
Does error reoccur?
Is toner cartridge setting?
Is toner lock lever setting?
Does error reoccur?
Is an error message indicated?
Is the error issued again?
Is an error message indicated?
Is the error issued again?
Is an error message indicated?
Is the error issued again?
Reset ID unit.
Turn power ON again.
Replace ID Up/Down
sensor.
Reset ID unit.
Turn power ON again.
After check connections
of cable between Toner
sensor PCB and PU
PCB, replaceToner
sensor PCB.
Replace PU PCB
Reset belt unit.
Turn power ON again.
Check cable connec-
tions and, replace PU
PCB
After cleaning for fuser
connector, reset.
Turn power ON again.
Check cable connec-
tions and replace PU
PCB
Set toner cartridge.
Turn a lock lever of toner
to a fixed position.
Replace toner sensor or
assembly.
Turn on the power
again.
Leave the printer as is
for 30 minutes, and turn
on the power again.
Turn on the power
again.
Leave the printer as is
for 30 minutes, and turn
on the power again.
note)
Turn on the power
again.
Leave the printer as is
for 30 minutes, and turn
on the power again.
Error detected at
ID position of Up/
Down(142 = C)
ID unit fuse
cannot be discon-
nected. (150 = Y,
151 = M, 152 = C,
153 = K)
Belt unit fuse
cannot be discon-
nected.
Fuser unit fuse
cannot be discon-
nected.
Error detected by
toner sensor. (160
= Y, 161 = M, 162
= C, 163 = K)
It does not occure
in factory default
setting.
Thermistor Slope
Error
Compensation
Thermistor Error
Upper Side
Thermistor Error
Yes
No
Yes
No
Yes
Yes
No
No
Yes
Yes
No
Yes
Yes
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Error DescriptionMessage Cause Solution