Oki Data CONFIDENTIAL
43827101TH Rev.2 204 /
Feed motor drive cord, ID
motor drive cord, belt motor,
ID-up motor drive cord, fuser
drive cord
Feed motor drive cord, ID
motor drive cord, belt motor,
ID-up motor drive cord
Feed motor, belt motor, ID up-
motor
Confirmation Tasks
Check the connected states of the cords.
Check for any incomplete connection or skew insertion of the
HOP connector, DCID connector, DCHEAT connector,
BELTIDUP connector and RELAY connector of the PU PCB.
Check for any incomplete connection or skew insertion, and
examine the cords visually to see if they have any assembling
problem.
Check to make sure that none of the cords is caught under any
assembled part of the printer.
Unplug the HOP connector of the PU PCB, and confirm the
following on the cord side:
Short-circuiting between pin 1 and FG
Short-circuiting between pin 2 and FG
Short-circuiting between pin 3 and FG
Short-circuiting between pin 4 and FG
Unplug the BELTIDUP connector of the PU PCB, and confirm
the following on the cord side:
Short-circuiting between pin 1 and FG
Short-circuiting between pin 2 and FG
Short-circuiting between pin 3 and FG
Short-circuiting between pin 4 and FG
Short-circuiting between pin 5 and FG
Short-circuiting between pin 6 and FG
Short-circuiting between pin 7 and FG
Short-circuiting between pin 8 and FG
Unplug the connectors of the respective PCBs, and confirm that
there are the following resistances between the pins of the cord
side:
HOP connector of PU PCB
Between pin 1 and pin 2: Approx. 3.5
Ω
Between pin 3 and pin 4: Approx. 3.5
Ω
BELTIDUP connector of PU PCB
Between pin 1 and pin 2: Approx. 6
Ω
Between pin 3 and pin 4: Approx. 6
Ω
Between pin 5 and pin 6: Approx. 3.5
Ω
Between pin 7 and pin 8: Approx. 3.5
Ω
Action at NG
Correct the connection
properly.
Replace the cord with a
normal one.
Replace the cord, and
correct the assembling
to make it normal.
Replace the feed
motor, ID motor, or belt
motor.
(5-2-4) Check of connections
Confirmation Items
To Next Page
Loading...
