43856301TH Rev.3
117 /
Oki Data CONFIDENTIAL
5. Maintenance Menu
5.6 Printer boot menu list
While pressing the SET button, turn on the power to display the Boot Menu.
Memo
To display the Boot Menu, entry of password is required. Default value of password
is "aaaaaa".
Category Item Setting value Function
Enter
Password
************ Enter password to enter Boot Menu.
Enter the password of 6 to 12 digits of alphanumeric.
The initial value is "aaaaaa".
Parallel
Setup
Parallel Enable Setting Valid/Invalid of parallel interface.
Disable
Bi-Direction Enable Setting Valid/Invalid of bi-direction of parallel
interface.
Disable
ECP Enable Setting Valid/Invalid of ECP mode.
Disable
Ack Width Narrow Setting the ACK width when receiving the compatible
data.
NARROW = 0.5 μs
MEDIUM = 1.0 μs
WIDE = 3.0 μs
Medium
Wide
Ack/Busy
Timing
Ack in Busy Setting order of outputting the BUSY signal and the
ACK signal when receiving the compatible data.
Ack while Busy
I-Prime 3 microseconds
50 microseconds
Setting Valid time/Invalid of the I- PRIME signal
Disable
Offline
Receive
Enable Setting Valid/Invalid of the function that enables to
keep the signal reception possible without changing
I/F signal even when an alarm is issued.
Disable
Category Item Setting value Function
USB
Setup
USB Enable Setting Valid/Invalid of USB interface.
Disable
Speed 480Mbps Setting the maximum transfer speed of USB
interface.
12Mbps
Soft Reset Enable Setting Valid/Invalid of Soft Reset.
Disable
Offline
Receive
Enable Setting Valid/Invalid of the function that enables to
keep the signal reception possible without changing
I/F signal even when an alarm is issued.
Disable
Serial
Number
Enable Setting Valid/Invalid of USB serial number.
Disable
Security
Setup
Job Limitation Off Limits the job to accept. The encrypted
authentication print only is accepted.
It is displayed when the optional internal hard disk is
Encrypted Job
Reset Cipher
Key
Execute Re-generates the encryption key that is used in the
encrypted hard disk.
It is displayed when the optional internal hard disk
is installed, and the encrypted hard disk function is
made valid.
Storage
Setup
Check File
System
Execute Resolves the un-match between the actual (free)
space and displayed free space of file system, and
recovers the control data (FAT information.)
Check All
Sectors
Execute Recovers the HDD sector information defect and un-
match of the above file system.
Enable HDD No A printer can start up even if HDD cannot start as
it is damaged when it is installed, by setting "No"
regardless of the HDD installation as a printer
recognizes that HDD is not installed.
Yes
Erase HDD Execute Deletes all data stored in a hard disk so that the
data cannot be recovered.
It is displayed when the optional internal hard disk is
installed.
Enable
Initialization *
No
Yes
The internal hard disk and flash memory are set so
that they cannot be changed including initialization.
*: It is displayed when [Function set] – [Print
tabulation]– [Tabulation function] is set to [Valid] .
Power
Setup
Power Save Enable Setting Valid/Invalid of the save power mode.
Disable
Language
Setup
Language
Initialize
Execute Deletes the message file in a flash memory.
To Next Page
Loading...
