43856301TH Rev.3
192 /
Oki Data CONFIDENTIAL
7. Troubleshooting and repair procedure
Solution: Set the encryption strength to "Weak".
How to change encryption strength with Telnet
Note! T
elnet cannot be used if it remains in the default setting. To change the
encryption strength, Telnet must be set to Enable.
S
elect the command prompt (DOS prompt) and enter "Telnet <printer IP
address>", and press Return.
Estab
lish connected using administrator user name and password
Select the menus in this order: [4: Security Config] [5: Cipher (SSL/TLS)]
[2: Cipher Strength]. Then, change the cipher strength as desired (1: Strong, 2:
Standard, 3: Weak).
To Next Page
Loading...
