43856301TH Rev.3
48 /
Oki Data CONFIDENTIAL
3. Set up
(2) Installation of duplex unit
This unit is used for printing on two sides of paper.
Note! F
or two-sides printing, it is recommended to add expansion memory. For
details, see "Expansion memories."
(2)-1. Turning OFF the printer power and disconnecting the power cord
Note! If an expansion memory is installed with the power switched ON, the printer
may be broken.
(2)-2. Peeling the protective tapes off the duplex unit
(2)-3. Install Duplex Unit
Insert the duplex unit into the lower part on the back of the printer as far as
it will go.
Ensure that the claw on either side of the duplex unit is securely
accommodated in the hole of the printer.
Type: DXU-C4D
To Next Page
Loading...
