Oki IP-5620 - Reloadable Cartridge Replacement

30
Reloadable cartridge replacement
This section describes the reloadable cartridge replacement procedure.
Note
- Check that the colors and types indicated on the ink cartridge tail section’s color identification label and the
board’s color identication label are the same.
- Usually a small quantity of ink remains in the used ink cartridge removed from the cartridge holder. This is normal.
- Always replace the board together with the used ink cartridge.
- Once an ink cartridge has been set to a cartridge holder, do not remove it until the ink has been entirely used. If a
cartridge that still contains ink is removed and inserted again, ink end may not be detected correctly.
- To temporarily put aside an ink cartridge that still contains ink, store it using the cartridge holder IP5-320 (sold
separately) without removing it from the holder.
Consumables
Cartridge assembly
Board protective sheet
Spout
Upper plate
Color identication label
(ink cartridge back)
Color identication label
Tail section
Lower plate
Caution label
Ink cartridge for cartridge holder Board
Cartridge holder
Cartridge holder cover
Tail section xing plate