Oki IP-5620 - Waste Ink Bottle Replacement; Waste Ink Bottle Replacement Procedure

34
Waste ink bottle replacement
This section explains the waste ink bottle replacement procedure. There are two situations that require
the waste ink bottle replacement procedure:
- When no waste ink bottle is installed
- When the waste ink bottle is full
The procedure for each case is described below.
Note
- Do not replace the waste ink bottle during printer operation.
- When replacing the bottle, use caution not to spill the ink. Use protective paper to prevent soiling.
Waste ink bottle replacement procedure
1
Remove the bottle from the waste ink spout
(tube) by slightly tilting the full waste ink
bottle.
2
Put the cap on the bottle and remove the
bottle.
3
Wipe o any ink stains around the waste ink
bottle.
4
Install a new (empty) waste ink bottle.
5
The following message is displayed to reset
(clear) the waste ink counter.
#BOTTLE EMPTY?
*YES
#BOTTLE EMPTY?
*NO
Note
- The printer automatically calculates waste ink with
a counter and displays the message prompting
replacement of the waste ink bottle when the
waste ink bottle is full. As there is no sensor for the
waste ink level, this calculation is just an estimate.
Therefore, if the waste ink counter is reset (set to
*YES) and the bottle is not empty, the waste ink
may overow.)
6
Select “BOTTLE EMPTY? * YES” and press
key.
Waste ink spout