Scanning With the Machine6-22
" A maximum of 64 characters can be entered.
Registering Speed Dial Destinations (LDAP Search)
E-mail addresses can be registered as speed dial destinations by using infor-
mation on the LDAP server. A maximum of 250 speed dial destinations can
be registered.
" To connect to an LDAP server, settings for LDAP SETTING must be
specified.
" Machine key operations cannot be used to register an FTP address or
SMB address as a speed dial destination. These addresses can be
registered with the Setup Utility.
" Speed dial destination numbers 221 to 250 are reserved for register-
ing FTP addresses and SMB address from the Setup Utility.
1 In the main screen (Scan mode), press the or key to select UTIL-
ITY
, and then press the ENTER key.
2 Press the or key to select DIAL REGISTER, and then press the
ENTER key.
3 Press the or key to select SPEED DIAL, and then press the ENTER
key.
4 Use the keypad to type in the number (between 1 and 220) for the speed
dial destination, and then press the ENTER key.
5 Press the or key to select LDAP SEARCH, and then press the ENTER
key.
" If an LDAP server is not specified, LDAP SEARCH does not
appear.
6 Press the or key to select NAME or E-MAIL, and then press the
E
NTER key.
" To search registered names, select NAME. To search e-mail
addresses, select
E-MAIL.
7 Use the keypad to type in the search keyword (maximum of 10 charac-
ters), and then press the E
NTER key.
The search begins, and the search results appear after a while. If no data
matches the search keyword,
NOT FOUND appears for about two sec-
onds.
" For details on entering/editing text, refer to “Entering Text” on
page A-6.
To Next Page
Loading...
