Replacing Consumables7-10
Replacing All Toner Cartridges at the Same Time
Note
Be careful not to spill toner while replacing a toner cartridge. If toner
spills, immediately wipe it off with a soft, dry cloth.
By selecting the
EJECT MODE in the PRINTER MODE menu, all toner car-
tridges can be replaced at the same time.
Follow the procedure described below to use the EJECT MODE.
1 With the main screen displayed, press the key to display the PRINTER
MODE screen.
2 Press the key to select T/C CHANGE and then press the ENTER key.
3 Press the key to select EJECT MODE and then press the ENTER key.
4 Perform the operations described in steps 6 through 15 of “Replacing a
Toner Cartridge” on page 7-4 through 7-9 to replace the magenta toner
cartridge.
" To exit EJECT MODE, press the STOP/RESET key.
5 Follow the same procedure to replace the cartridges for the cyan, black,
then yellow toners.
6 Press the STOP/RESET key to reset the machine.
" The machine must complete a calibration cycle (less than 2 min-
utes) after a toner cartridge has been replaced. If you open the
scanner unit or front cover before the machine is reset, the calibra-
tion stops, then starts over again after the cover is closed.
To Next Page
Loading...
