Oki MC160 - Registering Group Dial Destinations

Scanning With the Machine6-24
" For details on entering/editing text, refer to “Entering Text” on
page A-6.
7 Use the keypad to edit the e-mail address, and then press the ENTER key.
The edited settings are saved, and the
DIAL REGISTER menu appears
again.
" If the edited speed dial destination is registered in the favorite list
or with a group dial destination, a confirmation message asking
whether or not to keep the destination registered as it is appears
after the operation in step 7 is performed. To keep the destination
registered as it is, select
Yes. To cancel the registration, select
No.
Registering Group Dial Destinations
An e-mail address can be registered with a group dial destination. A maxi-
mum of 20 group dial destinations can be registered. (A maximum of 50
e-mail addresses can be registered with one group.)
" The addresses that can be registered as group dial destinations are
limited to addresses registered as speed dial destinations or as other
group dial destinations.
1 In the main screen (Scan mode), press the or key to select UTIL-
ITY
, and then press the ENTER key.
2 Press the or key to select DIAL REGISTER, and then press the
ENTER key.
3 Press the or key to select GROUP DIAL, and then press the ENTER
key.
4 Use the keypad to type in the number (between 1 and 20) for the group
dial destination, and then press the E
NTER key.
5 Use the keypad to type in the group name, and then press the ENTER key.
" For details on entering/editing text, refer to “Entering Text” on
page A-6.
6 Use the keypad to type in the number (between 1 and 220) for the speed
dial destination to be added to the group, and then press the E
NTER key.
The information registered for the selected speed dial destination
appears.
7 Press the ENTER key again.
8 To register another speed dial destination, press the or key to select
ADD, press the ENTER key, and then repeat the procedure from step 6.
9 To finish registering speed dial destinations, press the or key to select
FINISH, and then press the ENTER key.