Maintaining the Machine 8-3
Do not cover the machine immediately after using it. Turn it off and wait
until it cools down.
Do not leave the machine’s covers open for any length of time, especially
in well-lit places; light may damage the toner cartridges.
Do not open the machine during printing.
Do not tap media stacks on the machine.
Do not lubricate or disassemble the machine.
Do not tilt the machine.
Do not touch the electrical contacts, gears, or laser devices. Doing so may
damage the machine and cause the print quality to deteriorate.
Keep media in the output tray at a minimum level. If the media is stocked
too high, your machine may experience media misfeeds and excessive
media curl.
When lifting the machine, grasp
the areas shown in the figure.
Keep the machine level to avoid
toner spillage.
Before moving the machine,
remove the dust cover, and fold
up Tray 1.
If the optional lower feeder unit,
attachment and duplex option
are installed, remove them and
move them separately.
If you get toner on your skin,
wash it off with cool water and a
mild soap.
CAUTION
If you get toner in your eyes, wash it out immediately with cool water
and consult a doctor.
Make sure any parts removed during cleaning are replaced before you
plug in the machine.
21kg
46 lbs
To Next Page
Loading...
Need help?
General
