Oki MC573 - Sending Scanned Data as an E-mail Attachment

- 115 -
5. Scan
Sending Scanned Data as an E-mail Attachment
This section describes how to send scanned data as an e-mail attachment.
• Before Using Scan To E-mail
• Entering E-mail Address to Send E-mail
If the machine is set up from [Easy Setup] > [E-mail Setting], skip Before Using Scan To E-
mail. If the information is not set, set up in the following procedure.
1
Check the information related to E-mail following the steps in "Checking the
Setting Information".
2
Press [Device Settings] on the touch panel.
3
Press [Easy Setup].
4
Enter the administrator name and password, and then press [OK].
The factory default administrator name and password are "admin" and "999999" respectively. If the administrator
password is changed after installing the machine, enter the updated password.
5
Press [Skip>>] repeatedly to display [E-mail Setting].
6
Press [Next].
7
Follow the onscreen instruction to enter the information checked in Step 1.
E-mail Setup (Advanced Manual)
Before Using Scan To E-mail