- 74 -
2. Setting Up
1
Turn the machine on.
If the [Do you want to Set-up wireless?] message appears, select the [Do not show next time.] check box, and
then press [No].
2
Press [Device Settings] on the touch panel.
3
Press [Admin Setup] on the touch panel.
4
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "999999"
respectively.
5
Press [Network Menu].
6
Press [Network Setup].
7
Press [Wireless(AP Mode) Setting].
The message below is displayed for about five seconds.
8
Press [Enable].
To Next Page
Loading...
