Oki ML1120 - Removing Continuous Forms

ML1120/ML1190 eco User’s Guide – Paper handling > 37
3. Check the position of the tear-off perforations (1) relative
to the paper cutter (2).
(a) To advance the forms, continue to hold down the
TEAR button and then the SEL button.
(b) To retract the forms, continue to hold down the
TEAR button and the LF/FF button.
4. Release the buttons after the tear-off perforations have
been aligned with the paper cutter.
R EMOVING CONTINUOUS FORMS
1. Tear off the continuous forms. See “Tearing off continuous
forms” on page 36.
2. Press the SEL button to set the printer off-line and
reposition the continuous forms in the printer.
3. Press the LOAD/EJECT button to move the front edge of
the continuous forms backwards to the Pin Tractors.
1
2
NOTE
If the specified correction range is more than +_ 3.53 mm
(20/144 in) for ML1120 eco and +_ 4.23 mm (30/180 in) for
ML1190 eco, the paper cannot be removed.
NOTE
If sprocket holes of the last page of the forms disengage from
the sprocket pins, do not attempt to eject the paper to avoid
the possibility of a paper jam.