Oki ML1120 User Manual

ML1120/ML1190 eco User’s Guide – Specifications > 99
S PECIFICATIONS
ML1120 ECO
ITEM SPECIFICATION
Product Name ML1120 eco
Model No. D22400B
Print method Impact dot matrix
Print head 9 pins, 0.3mm (0.012 in) diameter
Print direction Bi-directional, short-line-seeking printing
Print speed
High Speed Draft (HSD)
Near Letter Quality (NLQ)
Utility
333cps @ 10 cpi
62.5 cps @ 10 cpi
250 cps @ 10 cpi
Line Feed (LF) time Approximately 52 ms per line for LF of
4.23 mm (1/6 in)
Form Feed (FF) speed Approximately 101.6 mm/s (4 in/s)
Paper feed control Paper feed: yes
Vertical tab: yes
Direct line feed: yes
Duplication capability Continuous forms: the original page +4 more
pages (total maximum paper thickness less
than 0.325 mm)
Cut sheet: the original page +4 more pages
(total maximum paper thickness less than
0.325 mm)
Feeding direction Feed forward
Feed backward
Feed upward
Feeding mode Friction feed mode (top)
Pin tractor feed mode (rear)
Pin tractor feed mode (bottom)
Continuous forms tape tail
detection method
Detected when remaining paper is
approximately 46 mm long. It can, however,
print till about 6 mm from the paper bottom
(measured at the centre of the characters).
(The print accuracy of the last page cannot
be guaranteed.)

Oki ML1120 Specifications

General

Noise level	49.7 dB
Maximum duty cycle	18000 pages per month
Maximum number of copies	9 copies
Power requirements	120 - 220V
Dimensions (WxDxH)	889 x 587 x 379 mm

Weight and Dimensions

Dimensions (W x D x H) (imperial)	35 x 23.1 x 14.9 \