Oki ML1120 - Page 58

ML1120/ML1190 eco User’s Guide – Operating instructions > 58
Rear feed
menu
Line Spacing Select line feed
pitch.
6 LPI
8 LPI
Form Tear-
Off
Select manual or
auto as the method
to advance a
continuous form to
the form tear-off
position.
Manual
500 ms
1 sec
2 sec
Skip Over
Perforation
Select whether to
skip over
perforation or not.
(When a skip over
perforation setup
command is
received, the
received command
is given priority.)
Yes (25.4 mm/ 1 in)
No
Page Length Select the length of
a continuous form.
279.4 mm(11 in)
296.3 mm
(11 2/3 in)
304.8 mm (12 in)
355.6 mm(14 in)
431.8 mm(17 in)
76.2 mm(3 in)
82.6 mm(3.25 in)
84.7 mm(10/3 in)
88.9 mm(3.5 in)
93.1 mm(11/3 in)
101.6 mm(4 in)
127.0 mm(5 in)
139.7 mm(5.5 in)
152.4 mm(6 in)
177.8 mm(7 in)
203.2 mm(8 in)
215.9 mm(8.5 in)
Cut position
adjust
Select an
adjustment value
for the position to
cut the end of a
continuous form.
(In 1/144 in
increments)
-20 – -1
0
+20 – +1
MENU ITEM FUNCTION SETTING