Oki ML1120 User Manual

ML1120/ML1190 eco User’s Guide – Troubleshooting > 88
No printing takes place
SEL indicator is unlit. The printer driver is not
installed properly.
Re-install the printer
driver correctly.
The printer has just
stopped printing.
Press the SEL button.
There is no paper in the
printer.
Load paper.
SEL indicator is
illuminated but no
printing takes place.
Interface cable is
disconnected.
Reconnect the interface
cable.
Wrong interface cable
has been used.
Use correct interface
cable.
The print head is
moving but no printing
takes place.
The ribbon cartridge
has not been installed.
Install the ribbon
cartridge.
Print position offset
The horizontal printing
position is offset.
The start position may
change after the printer
is powered on.
When the printer is
powered ON, switch
from off-line mode to
on-line mode by
pressing the SEL
button. Reset the start
position. You must set
the Power Switch to OFF
before you change the
start position.
Printing slows down
Print direction changes
suddenly to
unidirectional.
When the print head
overheats, the printer
automatically starts
unidirectional split
printing.
When the print head
temperature drops
sufficiently, the printer
will return to its original
operation.
PE warning
The print carriage does
not operate.
There is contamination
on the carriage shaft.
Clean any paper dust
and contamination from
the carriage with a dry
cloth.
PROBLEM CAUSE ACTION

Oki ML1120 Specifications

General

Noise level	49.7 dB
Maximum duty cycle	18000 pages per month
Maximum number of copies	9 copies
Power requirements	120 - 220V
Dimensions (WxDxH)	889 x 587 x 379 mm

Weight and Dimensions

Dimensions (W x D x H) (imperial)	35 x 23.1 x 14.9 \