The lower red line on the ribbon protector shows the baseline of the current printing position. Use this
when positioning the Top of Form.
The Top of Form is automatically saved in the printers static memory. Powering OFF the unit will NOT
change the Top of Form. You must reset the Top of Form to change it.
· Release TOF/Quiet. The paper advances from the initial print position to the tear off position.
To check the initial print position, perform the following procedure.
· Press SEL until the SEL lamp goes out. The printer is deselected.
· Press and hold TOF/Quiet. The paper will retract to the initial print position.
· Release TOF/Quiet. The paper will advance to the forms tear off position.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
To Next Page
Loading...
Need help?
General
