Page: 34
Service Guide ML390/391
Chapter 2 Principles of Operation
2.4.06 Semi-Automatic Sheet Feeder (SASF) Operation
When the paper release lever is set for friction feed paper, opening the bail arm causes the SASF switch
to close. The line feed motor feeds two inches of paper. SASF motion stops after two inches of paper feed
motion and paper-end is detected.
SASF should be used for loading tractor feed paper. Okidata recommends using SASF instead of
pressing FORM FEED. Since the paper bail is opened for SASF, there is less chance of jamming.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
To Next Page
Loading...
Need help?
General
