ML690/ML691 User’s Guide 47
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
Rear Feed
(Push)
(cont.)
Form Tear-Off
5
Specify manual form paper
advancement or select a time;
when printer is idle for .5, 1 or
2 seconds, paper is advanced
from the current print position to
the tear position. When data is
received, paper is moved to its
original printing position.
Manual, 0.5 sec, 1 sec, 2 sec
Skip Over Perforation Specify whether to skip over
perforations or not. When a skip-
over command is received, it is
given priority. If your software has
its own page formatting controls,
leave the default setting. To set
the printer to go to the next page
when it comes within 1” (25 mm)
of the bottom of the page, change
the setting.
No, 25.4 mm (1”)
Page Width
4
(only
displayed for ML691)
Change to 8” to print on narrow
paper.
13.6”, 8”
To Next Page
Loading...
