Oki ML690 - Page 72

ML690/ML691 User’s Guide 72
make it easier to mount the ribbon cartridge.
Holding the sides of the ribbon guide slope
it downward until the ribbon guide comes
in line with the slot of the printhead.
NOTE: Make sure that the guide is pushed to the end
of the printhead.
Move the printhead horizontally to make sure
that the ribbon is properly installed.
7.
8.
In the direction indicated by the arrows,
insert the pins at both ends of the ribbon
cartridge (1) into the U grooves (2) in the
printer until the ribbon cartridge is fully locked.
NOTE: It may be easier to mount the ribbon cartridge
in place if you align it with the topside of the
grooves. Also, a slightly loose ribbon may
6.