Oki ML690 - Page 87

ML690/ML691 User’s Guide 87
PROBLEM CAUSE SOLUTION
Improper continuous forms feed
No line feed, and no paper
feed.
Paper is off the Pin Tractors. Reload paper correctly.
The adjust lever position does not match
the paper type.
Set the adjust lever to the correct position.
Paper distortion or jam. Forms are loaded with their left holes out of
line with the right ones.
Load forms with their left holes in line with
the right ones.
Inadequate distance between the left and
right Pin Tractors, making for loose paper.
Relocate the Pin Tractors to tighten the paper.
Skewed paper feeding. Move the paper to make it straight.
Paper movement is blocked. Remove the blockage.
Paper source is too far from the printer. Move the paper source nearer to the printer.
Paper not specied for the printer. Use paper types specied for this printer.
Several blank lines appear in
the print-out
Skip-over perforation spacing is set. Cancel the skip-over perforation spacing.
The selected skip-over
perforation spacing does not
match the physical tear-off
perforation positions.
The paper length selected in the application
does not match the physical paper length.
Match the paper length selected in the
application with the physical paper length in
use.
Select the paper length in number of lines in
the application.
Abnormal switch-over between cut sheet and continuous forms modes
No cut sheet feed. The printer is in continuous forms mode. Set the Paper Type lever to cut sheet mode.
No continuous forms feed. The printer is in cut sheet mode. Set the Paper Type lever to continuous forms
mode.