Oki PT390 - 2. AC Adapter and Paper Specifications; AC Adapter Details; Thermal Paper Requirements

6
2. AC Adapter and Thermal Roll Paper
2-1. AC adapter
Only use the AC adapter specified below.
Model name: KA02951-0120
Input: 100 to 240V AC, 50/60Hz-
Output: DC24V±5%, 1.5A
Caution: Only use authorized AC adapters.
Caution: Do not use the bundled AC adapter and Power cable for any
electrical equipment other than this printer.
2-2. Paper specification (Thermal paper)
Be sure to use thermal roll paper that conform to the following specifications.
- Paper width: For paper 83mm wide, 83
0
-1.0
mm 80mm wide, 80
0
-1.0
mm
For paper 60mm wide, 60
0
-1.0
mm 58mm wide, 58
0
-1.0
mm
- Outside diameter: For paper 75 to 90µm thick, φ102mm or less
For paper 90 to 150µm thick, φ90mm or less
- Core diameter: For paper 75 to 90 µm thick, φ12±0.5mm (inside)
/φ18±0.5mm (outside)
For paper 90 to 150µm thick, φ25.4±0.5mm (inside)
/φ32±0.5mm (outside)
- Printed surface: Outside of the roll
- Treatment of end of paper: The roll paper must not be glued to the core. The
end of the paper must also not be folded back.
Note: Do not use rolls that have rough sides or sides from which pieces of paper
extrude. Using such rolls could cause a printer failure.