Oki PT390 - C-4.Setup Items

85
C-4.Setup Items
Setup group items
No.
Setup group item
Explanation
1
MEMORY SWITCH
Enters the mode for MEMORY SWITCH-related settings.
2
CUSTOMIZE VALUE
Enters the mode for CUSTOMIZE VALUE-related
settings.
3
SERIAL INTERFACE
CONDITION
Enters the mode for SERIAL INTERFACE
CONDITION-related settings.
4
OTHER
Enters the mode for other types of settings.
5
RETURN TO SETUP MENU
Returns to the setup mode menu.
Setup items and their details
(1) MEMORY SWITCH setup items
No.
Item
Explanation
Detail Setup Item
1
POWER ON
STATUS
- Specifies reporting the power-on state.
ENABLE
DISABLE
2
RECEIVE
BUFFER
- Specifies the capacity of the receive buffer.
45BYTE
4KBYTE
3
BUSY
CONDITION
- Status designation when printer turn is busy.
BUFFERFULL:
Turns busy when receive buffer is full.
OFFLINE/BUFFERFULL:
Turns busy when receive buffer is full or off-line.
BUFFERFULL
OFFLINE/BFUU
ERFULL
4
RECEIVE
ERROR
- Specifies how to handle receive errors
- This item is valid only for the serial interface.
IGNORE
?PRINT
5
AUTO LF
- Specifies automatic line feed using the CR code.
- This item is valid only for the Parallel interface.
ENABLE
DISABLE
6
DSR(#6)
RESET
- Specifies the reset operation using the DSR (#6)
signal.
- This item is valid only for the serial interface.
ENABLE
DISABLE
7
INIT(#25)
RESET
- Specifies the reset operation using the INIT (#25)
signal.
- This item is valid only for the serial interface.
ENABLE
DISABLE
8
INIT(#31)
RESET
- Specifies reset using the INIT (#31) signal.
- This item is valid only for the parallel interface.
ENABLE
DISABLE
9
COVER
OPEN
ERROR
- Specifies how to handle a cover open error during
printing.
AUTO RECOVERY:
When a cover is closed, Printer is recovery
automaticity.
RECOVERY BY CMND:
When a cover is closed, Printer is recovery by
command.
AUTO
RECOVERY
RECOVERY BY
CMND
10
BM CHECK
AT POW-ON
- Specifies the adjustment of the leading edge of the
paper at power-on.
- This item is valid only when the black mark
detection unit is installed and "BM sensor installed"
is set.
ENABLE
DISABLE
11
RETURN TO
UP
- Returns the menu to the selection mode for setup
group items.
-
12
RETURN TO
SETUP
MENU
- Returns the menu to the setup mode menu.
-