The CUSTOMER TEST package
is
controlled
by
means
of
selection
menus. Each of the diagnostic routines displays operating instructions
(where required)
on
the screen; the package, therefore.
is
extremely
easy
to
use.
USING CUSTOMER TEST
CUSTOMER TEST should be used whenever a faulty component
1s
suspected. Messages issued by CUSTOMER TEST are self-
explanatory, and the information you collect
--
and can pass along
--
by
running the package can markedly reduce repair time.
There
are
two
ways
to load CUSTOMER
TEST.
If the system
is
powered
off:
1.
Insert the CUSTOMER TEST diskette
in
drive A.
2.
Close the diskette drive door.
3.
Set the power ON/OFF switch to ON.
4.
When the power-up diagnostics have finished successfully, the
CUSTOMER TEST diagnostics are loaded, and the main menu
screen is displayed.
If
the system is already on:
1. Insert the CUSTOMER TEST diskette
in
drive
A.
2.
Close the diskette drive door.
3. Press and hold down the
CTRL
and
ALT
keys, then press the
DEL
key.
Release
aJI
three keys.
4. The CUSTOMER TEST diagnostics are loaded and the main menu
screen is displayed.
Once loaded, CUSTOMER TEST displays a message similar
to
the one
shown below:
C-2
DO
YOU
WISH
TO
RUN THE TESTS IN AUTOMATIC MODE? ('O'
=
NO,
'1'
= YES)
ENTER DESIRED ACTION -
INSTALLATION AND OPERATIONS GUIDE
To Next Page
Loading...
