@ FEDERAL COMMUNICATIONS COMMISSION
\2)
RADIO FREQUENCY INTERFERENCE STATEMENT
Warning: This equipment has been certified to comply with the limits for a Class
B computing device, pursuant to Subpart J
of
P
art
15
of
FCC
Rules. Only
peripherals (computer input/
output
devices, terminals, printers, etc.) certified
to comply with the Class B limits may be attached to this computer. Operation
with non-certified peripherals
is
likely to result in interference to radio
and
TV
reception.
INFORMATION
TO
THE
USER
This equipment generates
and
uses radio frequency energy
and
if
not installed
and used properly, i.e., in strict accordance with the operating instructions,
reference manuals
and
the service manual, may cause interference to radio
or
television reception. It has been tested and found to comply with the limits for
a Class B computing device pursuant to Subpart J
of
Part
15
of
FCC Rules, which
are designed to provide reasonable protection against such interference when
operated in a residential installation.
If
this equipment does cause interference to radio
or
television reception, which
can be determined by turning the equipment
off
and
on, the user
is
encouraged
to
try to correct the interference by one
or
more
of
the following measures:
• Reorient the receiving antenna.
• Relocate the computer with respect to the receiver.
• Move the computer away from the receiver.
• Plug the equipment into a different outlet so
that
equipment
and
receiver are
on different branch circuits.
• Check
that
PC
board mounting screws, connector screws,
and
ground
wires
are well secured.
• Check that
PC
board slot covers are in place when
PC
boards are not mounted.
If
necessary, the user should consult the dealer for additional suggestions.
The manufacturer cannot be held responsible for the interference caused by
unauthorized modifications to the computer.
Connecting
of
peripherals not supplied by the manufacturer to this computer,
requires the use
of
grounded shielded cables with in-line filter
if
needed.
To Next Page
